Care; Stripping Down - Dräger 8000 IC Instructions For Use Manual

Care

Clean and disinfect incubator thoroughly:
– after each change of patient
– at least once a week.
With septic patients:
– disinfect seals on hand ports daily.
Clean and disinfect the accessories, such as the suction
equipment, the flowmeter and the skin temperature
sensor in accordance with the relevant Instructions for
Use.

Stripping down

Switch off incubator. Disconnect from mains and
disconnect the medical gas supply.
Remove all accessories.
Empty water bottles/water container, otherwise risk of
microbial contamination. Observing hospital hygiene
regulations.
Water bottles:
Fold down back panel.
Allow water to flow back into bottles.
1 Remove bottles from holder and drain,
Hold connecting hose by cuff and detach from
connector on heater.
Unscrew bottle holder.
Water container:
Remove cover from water container.
1 Remove container from holder by lifting it up. Drain
water, observing hospital hygiene regulations.
Hold connecting hose by cuff and detach from
connector on heater.
2 Open hand port, remove seals from hand port
openings and close hand port again.
Pull climate sensor out of canopy.
When skin temperature control option has been used:
Disconnect skin temperature sensor.
Remove skin temperature sensor from inside
incubator.
3 Remove all hose seals.
4 Tilt canopy back as far as it goes.
Stripping down
1
1
2
3
4
Care
37