Table of Contents
Advertisement
Master Programming Level
Detector Programming
Pressing 1, while viewing the Point Program Screen, will allow the programmer to add, delete or change the programming of an addressable
detector. The following screen will be displayed by the control panel:
Add Detector
Pressing 1 while viewing the Detector Screen will display the following screen which allows the programmer to add a new detector address
to programming:
A flashing cursor will appear in the position of the first asterisk to the left. The programmer keys in the three digit detector address, such as
005. The screen will then ask whether the detector being added is wireless.
Select 1 for wired detector or 2 for wireless detector. When the choice is selected, the following screen will be displayed:
Press the down arrow key to view additional choices. Press the number corresponding to the desired selection to program that type to the
newly added detector. If the selected detector is a multi-criteria Fire (Photo)/CO detector, select 1 for Fire CO. When the type has been
selected, the following screen will be displayed:
NOTE: The system must be monitored by a Supervising Station when using carbon monoxide detection per The Requirements for the
Installation of Carbon Monoxide (CO) Detection and Warning Equipment, NFPA 720.
The programmer can continue adding detectors by pressing the ESC key which will return the display to the Add Detector Screen.
Delete Detector
DETECTOR
1=ADD
2=DELETE
3=EDIT
Detector Screen
A flashing cursor will appear in the position of the first asterisk to the left. The programmer keys in the three digit detector address, such as
005. When the last digit is keyed-in, the following screen will be displayed:
The programmer can continue deleting detectors by pressing the ESC key which will return the display to the Delete Detector Screen.
ES-50X Series Manual — P/N LS10129-000FL-E:D 4/26/2021
1=ADD
2=DELETE
3=EDIT
ENTER DETECTOR#
1=DETECTOR
2=DETECTOR:WIRELESS
DETECTOR TYPE
1=SMOKE(PHOTO)
2=USER-DEFINED-1
3=SMOKE(ION)
DETECTOR#
IS ADDED
Pressing 2 in the Detector Screen will display the Delete Detector Screen which allows the programmer to delete
a specific detector:
DELETE DETECTOR
ENTER DETECTOR#
Delete Detector Screen
DELETE DETECTOR
DETECTOR#
IS DELETED
DETECTOR
Detector Screen
ADD DETECTOR
Add Detector Screen
ADD DETECTOR
Add Detector Screen
DETECTOR TYPE
1=FIRE CO
through
2=USER-DEFINED-12
ADD DETECTOR
005
005
Programming
51
Advertisement
Table of Contents
