Honeywell Fire-Lite Alarms ES-50X Manual page 39

Optional Module Installation
Setting Printer Options

Refer to the documentation supplied with the PRN-7 printer for instructions on using the printer menu controls. Set the printer options (under
the menu area) as shown in the following table:
PRN-6F Printer Installation

When connected to the FACP via the ANN-S/PG module, the PRN-6F prints the status changes within the control panel and time-stamps the
printout with the time of day and date that the event occurred. It provides 80 columns of data on standard 9" x 11" tractor-feed paper. This
section contains information on connecting a printer to the control panel and setting the printer options.
Connecting PRN-6F Printer
Remote printers require a primary AC power source. If required for the fire alarm system configuration (for example, a Proprietary Fire
Alarm System), a remote printer requires a secondary power source (battery backup). Since a secondary power source is not provided as a
standard feature, a separate UL-listed Uninterruptible Power Supply (UPS) should be used. The building emergency power supply may be
used, as long as it meets the power continuity requirements of NFPA 72. Refer to NFPA 72 for further details.
Connect the remote printer to the FACP via the ANN-S/PG module using a standard DB-25 cable. One end of the cable will plug into the
DB-25 connector on the PRN printer and the other end plugs into the parallel connector on the ANN-S/PG module. Note that the 9-pin DB-
9 port on the ANN-S/PG is used to connect a serial printer. The 25-pin port is used for a Centronics parallel printer cable. Connect either a
serial or parallel printer, but not both at the same time.
Setting Printer Options
Refer to the documentation supplied with the PRN-6F printer for instructions on using the printer menu controls. Set the printer options
(under the menu area) as shown in the following table:
ES-50X Series Manual — P/N LS10129-000FL-E:D 4/26/2021
Option
Font
LPI
ESC Character
Bidirectional Copy
CG-TAB
Country
Auto CR
Color Option
Formien
Lines
Standard
Barcode
Barcode
Table 2.1 PRN-7 Setup Options
Option
Font HS Draft
LPI 6 LPI
ESC Character ESC
Bidirectional Copy ON
CG-TAB Graphic
Country E-US ASCII
Auto CR OFF
Color Option Not Installed
Formien
Lines 6LPI=60
Standard Exec 10.5
Table 2.2 PRN-6 Setup Options
Setting Option
HS Draft CPI
6 LPI Skip
ESC Emulate
ON I/O
Graphic Buffer
E-US ASCII Serial
OFF Baud
Not Installed Format
Protocol
6LPI=60 Character Set
Exec 10.5 SI.Zero
Off Auto LF
Unsecured
Setting Option
CPI
Skip
Emulate
I/O
Buffer
Serial
Baud
Format
Protocol
Character Set
SI.Zero
Auto LF
PAPER
BIN 1
BIN 2
SINGLE
PUSH TRA
PULL TRA
PAP ROLL
Setting
10CPI
0.5
LQ-2550
64K
9600 or 2400
7 Bit, Even, 1 Stop
XON/XOFF
Standard
On
On
Setting
10CPI
0.5
Epson FX-850
40K
9600 or 2400
7 Bit, Even, 1 Stop
XON/XOFF
Standard
On
On
12/72"
12/72"
12/72"
12/72"
12/72"
12/72"
Installation
39