Import And Export Of Data - Ecom EN3 Instruction Manual

To enable communication with the PC software DAS 5, the following settings
must be made in the menu Adjustments / Internal / WLAN:
Parameter
Access Point
Auto Connect
NOTE
For further information on importing from the PC software and export-
ing to the PC software, please refer to the operating instructions of
the corresponding PC software.

10.3.3 Import and Export of Data

To import plant data from a PC software (e.g. ecom-MiniDV) into the instru-
ment, proceed as follows:
• connect ecom-EN3 and PC via USB cable (if the connection is correct,
"USB" appears in the lower right corner of the display)
• select "Load data" and confirm with <Enter>
• answer the displayed question with YES (<F1>)
• decide if the data recorded can be cancelled (<F1> for YES / <F4> for NO)
• start the data transfer on your PC
NOTE
The instrument is used to add measured values to plant data, which
were created before with a PC software. These complete data sets,
consisting of plant data and measured values, can be exported from
the instrument and managed in a PC software.
ecom-EN3
Meaning Adjustment
Access Point
Yes
Page 59