Data Recording With Pc Software Ecom-Das 5 - Ecom EN3 Instruction Manual

To enable communication with the PC software DAS NT 2, the following set-
tings must be made in the menu Adjustments / Internal / USB:
Parameter
Transfer speed
Protocol
NOTE
For further information on importing from the PC software and export-
ing to the PC software, please refer to the operating instructions of
the corresponding PC software.

10.3.2 Data recording with PC Software ecom-DAS 5

The software "ecom-DAS 5" can be used to display and record measured
values. Via the MM card, customer and measurement data can be
exchanged between the software and the instrument. A recording of point
and continuous measurements can be done via USB or WLAN.
NOTE
A driver is required to communicate with the PC software DAS 5 via
the USB interface. To download and install the necessary USB
driver, see https://www.ecom.de/en/downloads.
To enable communication with the PC software DAS 5, the following settings
must be made in the menu Adjustments / Internal / USB:
Parameter
Transfer speed
Protocol
Page 58
Meaning
Meaning
Adjustment
1200 Baud
DAS = DAS NT 2
Adjustment
1200 ... 38400 Baud
Enhanced = DAS 5
ecom-EN3