Maintenance Functions For Cordless Handsets; Overview; Maintenance Functions For U.s.a. Models; List Of Maintenance Functions - Brother MFC260C Service Manual

9.2 MAINTENANCE FUNCTIONS FOR CORDLESS
HANDSETS

9.2.1 Overview

Section 9.2 applies to models with a cordless handset.
Cordless handsets have the built-in maintenance functions. Their menu and operating procedures
differ depending on the shipping destination of the machines. For U.S.A. models, refer to
9.2.2; for European modes,

9.2.2 Maintenance Functions for U.S.A. Models

9.2.2.1

List of Maintenance Functions

The table below lists the maintenance functions built in handsets of U.S.A. models.
To access one of these functions, press the Menu/OK, *, and # keys, enter the corresponding 3-digit
function code with the numerical keys, and then press the # key on the cordless handset.
Function
Code
086
195
196
197
198
NOTES • Pressing the Off key after entering only one or two digits restores the cordless handset to
• Entering an invalid function code does not display any error message so that the cordless
Section
Maintenance Functions for U.S.A. Models
Checking of Cordless Handset ID Code and Base ID Code
Measuring of RSSI (Received Signal Strength Indicator)
Measuring of BER (Bit Error Rate)
Version Information on Cordless Handset
EEPROM Parameter Initialization
the standby state.
handset superficially appears to accept the entry. If you make a mistake in entering a
code, therefore, press the Off key to return to the standby state and then go back to the
beginning of the procedure.
9.2.3.
Function
9-56
Section
Reference
Section (Page)
9.2.2.2 (9-57)
9.2.2.3 (9-58)
9.2.2.4 (9-59)
9.2.2.5 (9-59)
9.2.2.6 (9-60)
Confidential