Brother MFC260C Service Manual page 219

• After mounting the flat cable support plate, pass the ink supply tubes between the tube/cable
guide and the lower cover and then through the bent section of the tube support wire as shown
below.
Bent section of
tube support wire
Flat cable support plate
• After mounting the head cover, set the CR encoder strip so that the
(carriage motor side) and the
steps.
1) Hook the left end of the CR encoder strip on the left-hand strip support, aligning the
rectangular hole provided in the strip with the boss of the strip support.
2) Pass the strip through the CR encoder sensor located on the head/carriage unit by inserting it
into the opening of the head cover from left to right.
3) Hook the right end of the strip while pushing the left-hand strip support inwards.
• After replacement of the head/carriage unit, check that the CR encoder strip and PF encoder disk
are free of grease and ink. If they are stained with grease or ink, replace them.
• If you replace the head/carriage unit, make adjustments specified in
Black
Yellow
Cyan
Magenta
Tube/cable guide
Spring
Hook
mark points upwards as shown on
6 - 6 0
(Rear)
Tube guide
Sponge
When routing the ink
supply tubes through this
tube guide, do not overlap
them with each other.
marked end is to the right
-
page 6-50, using the following
Chapter 7, Section
Lower cover
(6_46_A)
7.2.
Confidential