Brother MFC260C Service Manual page 106

Error Message
*
(On color LCD)
Unable to Change XX
Unable to Clean XX
Unable to Init. XX
Unable to Print XX
Unable to Scan XX
Unable to use Phone XX
(On monochrome LCD)
Change Unable XX
Clean Unable XX
Init. Unable XX
Print Unable XX
Scan Unable XX
(On color LCD)
Unusable Device
Disconnect device
from front connector
& turn machine off &
then on
(On monochrome LCD)
Unusable Device
Disconnect device
from front connector.
Turn the machine off
& on by pressing
On/Off button on
control panel.
Unusable Device
Please Disconnect
USB Device.
Wrong Paper Size
* XX represents one of the error codes shown in "[ 2 ] Error codes contained in "MACHINE ERROR X X"
messages."
Cause
The machine has a
mechanical problem.
or
A foreign object such as a
clip or ripped paper is in the
machine.
*
A broken device has been
connected to the USB direct
interface.
A USB flash memory drive
that is not supported has been
connected to the USB direct
interface.
Paper is not the correct size.
Open the scanner cover and remove any
foreign objects inside the machine.
If the error message continues, see
Chapter 5, Section 5.1
"TRANSFERRING RECEIVED FAX
DATA"
machine so you will not lose any
important messages. Then, disconnect
the machine from the power for several
minutes and then reconnect it. (The
machine can be turned off for
approximately 24 hours without losing
faxes stored in the memory.)
Unplug the device from the USB direct
interface, then press On/Off (Power
Save) to turn the machine off and then
on again.
Unplug the device from the USB direct
interface.
Load the correct size of paper (Letter,
Legal or A4), and then press Black
Start (Mono Start) or Color Start.
4- 5
Action
before disconnecting the
Confidential