(4) For 120V series: Remove the power cord holder by removing the screw "g." Then release the
power cord from the cable guides (shown on the next page).
(5) Remove the power supply shield from the lower MJ/PS shield.
(6) Remove four "j" screws from the power supply PCB.
(7) Remove screw "h" from the MJ shield and take it off the lower MJ/PS shield.
(8) Remove screw "i" from the MJ PCB and take it off the lower MJ/PS shield.
For 120V series
Power cord
holder
MJ shield
Power supply shield
"g"
Power cord
Main-MJ (EXT)
harness (black)
Power cord
"j"
Tabs
3
Tab
"h"
MJ shield
Main-MJ (LINE)
harness (blue)
"i"
MJ PCB
CN1
CN2
"j"
"j"
2
4
"j"
Tighten four screws in
the order of
Power supply harness
6 - 4 5
"Y"
"Y"
Slit
Power supply PCB
to
.
"g": Taptite, cup B M3x12
"h": Screw, pan (s/p washer) M3x8
"i" and "j": Taptite, cup S M3x6
Cable tie
Lower MJ/PS
shield
Power supply
PCB
Slits
"X"
Lower MJ/PS shield
(6_39)
Confidential