Brother MFC260C Service Manual page 200

(4) Remove two screws "c" from the main PCB, then lift up the PCB.
(5) Remove the SDAA enclosure by unlatching it from the solder side of the main PCB.
(6) Remove screw "d" from the main PCB shield frame, then lift up the shield frame. (This screw
also secures the MJ/PS shield box.)
Align the edge of the
thermal conductor rubbers
with the L-shaped bosses
on the main PCB shield
frame.
L-shaped boss
Thermal conductor rubber
(For 200V series only)
Thermal conductor rubber
Carriage motor
harness
Paper feed motor
harness
PF encoder/registration
sensor harness
Models with color LCD
SDAA enclosure
"c"
"d"
Power supply harness
"c"
Main PCB
Main PCB shield frame
Purge cam switch harness
Ink cartridge sensor harness
Lower cover
"c": Taptite, cup S M3x6
"d": Screw, pan (s/p washer) M3x8
6 - 4 1
Models with monochrome LCD
SDAA enclosure
"c"
Main PCB shield frame
(6_36)
"c"
Main PCB
Confidential