If You Replace The Wlan Pcb (Only For Wireless Lan-Enabled Models); 1 ] Transfer Mac Address To The Main Pcb - Brother MFC260C Service Manual

On the cordless handset
The cordless handset is searching for the base unit.
(9) Enter the 4-digit PIN code obtained in step (1) above using the numerical keys and press the
Menu/OK key.
Notes • If the machine sounds three short beeps, indicating the failure of registration, it returns to
the "Register Handset" state. Perform steps (3), (4), (8), and (9) again.
• If you want to install another cordless handset, repeat steps (2) through (4), (8), and (9).
• Up to four cordless handsets can be registered to the machine.
On the machine (base unit)
(10) Press the Stop/Exit key. The machine returns to the standby state.
7.8 IF YOU REPLACE THE WLAN PCB (ONLY
FOR WIRELESS LAN-ENABLED MODELS)

[ 1 ] Transfer MAC address to the main PCB

(1) Press the Menu and Black Start (Mono Start) keys. Next press the , , ,
order to make the machine enter the maintenance mode.
(2) Press the 0 key twice.
The "SPECIAL MAINT" appears on the LCD.
(3) Press the 0 and 2 keys in this order.
The "PLS INPUT NO.0-A" appears on the LCD.
(4) Press the 8 key, and the main PCB gets the MAC address from the WLAN PCB. (This
operation backs up the EEPROM data stored on the WLAN PCB.)
The "E2PCOPY START" appears on the LCD.
NOTE: If an error is detected during the backup operation, the machine displays "E2P
BACKUP ERR!!" on the LCD and becomes inoperable. If it happens, turn the machine off and
check the connection between the WLAN PCB and main PCB, and then go back to step (1)
again.
(5) Press the Stop/Exit key to return to the initial stage of the maintenance mode.
MAC address: Media access control address
7-35
keys in this
Confidential