Brother MFC260C Service Manual page 434

Selector
No.
1
PictBridge command delay time
2
Extension of the "No. of CNG cycles
3 to be detected" for Easy Receive
mode
4 Recovery of cordless handset ID
5
Caller ID tone alert detection period
6
Transmission of caller ID wetting
7
pulse
Switching between DTMF and FSK
8
for caller ID
NOTE: Selectors 1 and 2 are applicable to PictBridge-enabled models.
NOTE: Selector 4 is applicable to models with cordless handset.
NOTE: Selectors 5 through 7 are applicable to the UK models.
NOTE: Selector 8 is applicable to the Chinese models.
Selectors 1 and 2: PictBridge command delay time
These selectors specify the PictBridge command delay time that applies when the machine responds
to the digital camera connected via PictBridge during negotiation. If the machine fails to receive data
from the digital camera, change the delay time.
Selector 3: Extension of the "No. of CNG cycles to be detected" for Easy Receive mode
In Easy Receive mode, if the machine fails to detect the CNG even after the setting made by selectors
4 and 5 on WSW26, extend the "No. of CNG cycles to be detected" by two cycles.
Selector 4: Recovery of cordless handset ID
Enabling this function automatically writes the cordless handset ID registered on the main PCB onto
the cordless PCB when the power is turned on if the ID on the cordless PCB is discrepant with the
one on the main PCB.
Selectors 5 and 6: Caller ID tone alert detection period
If the machine misdetects a tone alert for a caller ID, adjust the detection period with these selectors.
WSW54
(Function setting 19)
Function
App. 4-58
Setting and Specifications
No. 1 2
0 0 : 100 ms (default)
0 1 : 0 ms
1 0 : 50 ms
1 1 : 200 ms
0: No 1: + 2 cycles
0: Enable 1: Disable
No. 5 6
0 0 : 10 ms (default)
0 1 : 20 ms
1 0 : 30 ms
1 1 : 40 ms
0: Enable 1: Disable
(default)
0: DTMF 1: FSK
(default)
ms: millisecond(s)
Confidential