Brother MFC260C Service Manual page 224

Assembling Notes
• Before mounting the engine unit on the lower cover, make sure that the PF encoder/registration
sensor harness and the paper feed motor harness are routed through the cable guides on the inner
chute as shown on
• When mounting the engine unit on the lower cover, be careful not to crush the harnesses between
the unit and the cover. Mount the engine unit parallel to the lower cover so that the screws are
tightened securely.
• Route the harnesses as shown below.
Registration sensor PCB
Inner chute
ASSY
Ferrite core
Lower cover
Paper feed
motor harness
PF encoder/
registration
sensor harness
page 6-69.
(Rear)
Paper feed motor harness
(Left)
Top view
Carriage motor harness
6 - 6 5
Registration
sensor wires
(3-wire)
PF encoder
sensor wires
(4-wire)
PF encoder PCB
Purge cam switch harness
Lower cover
Confidential
PF encoder/
registration
sensor harness
(7-wire)
(6_55)