Brother MFC260C Service Manual page 103

Error Message
Data Remaining
Disconnected
Document Jam
DR Mode in Use
High Temperature
Hub is Unusable.
Image Too Long.
Image Too Small.
Cause
Print data is left in the
machine's memory.
Print data is left in the
machine's memory. The USB
cable was unplugged while
the computer was sending the
data to the machine.
The other person or other
person's fax machine stopped
the call.
The document was not
inserted or fed properly, or the
document scanned from the
ADF was too long.
The machine is set to
Distinctive Ring mode. You
cannot change the Receive
Mode from Manual to another
mode.
The print head is too warm.
A Hub or USB flash memory
drive with a Hub has been
connected to the USB direct
interface.
The proportions of your
photo are irregular so effects
could not be added.
The size of your photo is too
small to trim.
4- 2
Action
Re-start printing from your computer.
Press Stop/Exit. The machine will
cancel the job and clear it from the
memory. Try to print again.
Try to send or receive again.
Remove the jammed document.
(Only for models with ADF.)
Set Distinctive Ring to off.
Allow the machine to cool down.
A Hub or USB flash memory drive
with a Hub is not supported. Unplug
the device from the USB direct
interface.
Choose a regularly proportioned
image.
Choose a larger image.
Confidential