Table of Contents
Advertisement
Model:
Sh-MF1
7. Create a hook in the AIO frame as shown below.
Important:
-
Make sure not to cut below the rib, as shown in the diagram below. To do this,
cut to a depth of less than 2mm.
-
Create a new spring latch in the AIO frame above the rib, using a knife or
soldering tool (soldering tool is preferred, to prevent contamination).
-
If you use a soldering tool, set the temperature to about 260C.
8. Cut off the corner below the rib, and create a new latch as shown in the pictures.
9. Wait at least 10 seconds.
10. Remove any loose plastic chips.
11. Clean the "new" hook with an alcohol-soaked cloth.
12. Soak the spring in alcohol.
T
B
echnical
ulletin
Date:
03-Jun-13
PAGE: 5/7
No.:
RM052058a
Advertisement
Table of Contents
