Table of Contents
Advertisement
Model:
Sh-MF1
4.
Insert the power cord into the outlet, and then turn on the main power switch.
5.
Access System/Copy SP mode.
6.
Do this step only if you are installing the option on a machine that is already in use (not a new
machine):
If the customer wishes to continue using the same hard disk:
Execute all three SP modes below.
SP5-801-014 (Clear DCS Setting)
SP5-832-001 (HDD Formatting (ALL))
SP5-832-002 (HDD Formatting (IMH))
If customer wishes to replace the hard disk with a new one:
Execute SP5-801-014 only.
Note: If the customer continues using the same hard disk, the overwriting of the data stored on
the disk before the option is installed cannot be guaranteed. It is highly recommended to
replace the hard disk with a new one.
7.
Set SP5-836-001 (Capture Function (0:Off 1:On)) to a value of 0 (disable).
8.
Execute SP5-878-001 ([Option Setup：Data Overwrite Security).
Note: If the installation fails, "Installation failed" is displayed when this SP is executed.
9.
Print out the System Settings List and make sure that the option was installed successfully.
10. Turn off the main power switch.
11. Reattach the SD slot cover.
12. Reconnect the network cable.
13. Insert the power cord into the outlet and turn on the main power switch.
14. Execute SP5-990-005 (SP print mode Diagnostic Report).
15. Make sure that ROM number "D3775912B" and firmware version "1.02m" appear in both of the
following areas on the report (they must match):
"ROM Number / Firmware Version" – "HDD Format Option"
"Loading Program"
Configuring "Auto Erase Memory"
The following procedure is performed by the customer once the above Installation Procedure has been
completed.
1. Press [System Settings].
2. Press [Administrator Tools].
3. Press [Next] three times.
4. Press [Auto Erase Memory Setting].
T
B
echnical
(Performed by the Customer)
ulletin
Date:
1-Oct-13
PAGE: 3/5
No
.: RM052062
Advertisement
Table of Contents
