Bosch Rexroth IndraMotion MTX 09VRS Manual page 96

84/233 Bosch Rexroth AG | Electric Drives
Programming
7.2.6 Functions under Tools
Tools- Block Numbers
Automatic NC Block Numbering On/Off
Automatic CPL Block Numbering On/Off
Rexroth IndraMotion MTX 09VRS | Application Description
and Controls
//%N% Test %P%
//%N% G0 X1111
//%N% G1 X999 F1234
The ID %P% is used as a placeholder for the parameters of the Test subroutine,
which can be assigned in the paste cycles dialog box. All the blocks are then
transferred to the NC program.
Assigning a Graphic to a Parameter
It is possible to assign a graphic to a parameter. The graphic is displayed when
the parameter is activated.
Example: //%V% REAL %TN2% %GF% G82_R1.jpg %TN8%
The parameter of type REAL with the designation Token TN2 is assigned a
graphic; the graphic shows the content of token TN8 as text.
Use of Text Files
Instead of specifying a concrete text, a language-dependent text can be defined
using token numbers. For this, the corresponding texts have to be defined in a
text file. The text files are also saved to the User\Config path of the project. The
file name can be freely selected; it always contains the language ID
Name_yy.txt (yy=language ID, e.g.: DE for German). The name of the file to be
used is specified in the header under the keyword %ID%. If only one text file is
used, the name has to be specified in each header.
Creating own Graphics
An "empty" graphics file named "C0.jpg" is located in path "IndraWorks\con‐
fig". This graphics file can be used as a template with the help of a graphics
program (Paint, Photo Editor). It fits the size of the graphic to be used:
Graphics format:
Width: 9.76 cm or 223 pixels
Height: 8.19 cm or 262 pixels.
The template is saved in the same path, but under a new name.
The desired step size (1-10) can be selected for automatic block numbering.
Automatic NC block numbering is switched on or off. It is only effective if a
program is written continuously or if blocks are pasted. In doing so, the number
of the current NC block as well as that of the following NC block is determined.
In this case, pasting occurs with the preselected step size or with another pos‐
sible one (if the difference between the blocks is less than the step size).
Automatic CPL block numbering is switched on or off.
It is only effective if a program is written continuously or if blocks are pasted. In
doing so, the number of the current CPL block as well as that of the following
CPL block is determined. In this case, pasting occurs with the preselected step
size or with another possible one (if the difference between the blocks is less
than the step size).