Table of Contents
Advertisement
104/233
Bosch Rexroth AG | Electric Drives
Programming
Number of Correction Blocks
Unit of the Table (mm/inch)
Number of Decimal Positions
Operating the D-Correction Editor
F-key level
<F2>
<F3>
Add correc‐
Delete cor‐
1. Level
tion block
rection
block
File...
Edit...
2. Level
New...
Open...
File
Rexroth IndraMotion MTX 09VRS | Application Description
and Controls
Fig.7-14:
D-correction editor
A D-correction table can contain a maximum of 99 D-correction data sets (D1-
D99). The number of D-correction tables is unlimited.
The unit of a D-correction table can be determined on the basis of the column
headers of L1, L2, L3 and R ([mm] or [inch]).
The unit of a D-correction table is already determined from param‐
eter 9020 00010 of the configuration data during the creation of the
table and is stored with the table.
The number of decimal positions displayed is specified by parameters 6020
00021 and 6020 00022 in the configuration data.
General Information
Only the functions affecting the D-correction editor are described here. The
general operation of table editors is described in
page
96.
Functional Keys in the D-Correction Editor
The following table shows all functional keys of the D-correction editor:
F4
<F5>
Additive
Navigate...
Save As...
chapter 7.4.2 "Operation" on
<F6>
<F7>
<F8>
Print
Exit all zero
offsets
<F9>
Exit D-cor‐
rections
Exit D-cor‐
rections
Advertisement
Table of Contents
