Table of Contents
Advertisement
Application Description | Rexroth IndraMotion MTX 09VRS
Operating Mode Text Entry
Operating Mode Hybrid
Working in the Classic Operating Mode
Numerical Entry
Simple Calculation
This operating mode is pre-set in the first use and can be used in a particularly
effective way if there is a mouse. An operation without mouse is supported by
numerous shortcuts.
The classic operating mode can be recognized in the status display from the
information "CLASS".
The operating mode text entry changes the result display into an editable text
box for entering arithmetic expressions. At the same time, all function and op‐
erator keys as well as the operating keys that are only relevant for the classic
mode are enabled. Thus, this mode provides an entry medium for texts that are
interpreted and calculated as arithmetic expressions.
The text entry is recommended for more complex expressions as the expres‐
sion can be completely seen and checked before the calculation. Re-calcula‐
tions as they are often necessary in the classic mode can mostly be omitted.
The text entry is particularly suitable for an operation without mouse. The text
mode is moreover advantageous in recurring expressions with changing num‐
bers. For this purpose, the last expression should be copied into the display
using the clipboard and the new operands should then be entered by editing.
The text entry can be recognized from the status display "TEXT".
The hybrid operating mode combines the classic and the text entry mode. After
calculation of a result and after pressing the delete key "C", it is decided by
means of the following operating step in which form - classic or text entry - the
following calculation will be performed. If the entry focus is set to the display
field and entries are made there, the text entry mode is activated. If, however,
operating keys are actuated or shortcuts are used while the entry focus is not
on the display, this behavior will activate the classic operation by means of keys.
The hybrid mode spares the explicit switching between the modes. It can be
recognized from the status display "HYBR".
Performing a Calculation
Numbers are entered in the following way:
●
Enter the numbers and the decimal separator in the order from left to right.
A leading zero in front of the decimal separator does not have to be en‐
tered.
●
For the numerical entry, the numbers <0> to <9> are available as short‐
cuts. The decimal separator can be entered using the point or comma key.
You can also use the numeric keypad if the <NUM> key has been pressed
in advance.
●
A negative sign can only be entered if the display does not equal zero. For
the change of sign, you can use the "+/-" key and/or the shortcut <F9>.
●
Changeover from the floating point representation (e.g. the decimal point
separates the fraction from the integer) to the exponential representation
(mantissa followed by the exponent of the power of ten) by operation is
not intended. An operand is always entered in the floating point represen‐
tation. Calculation results with very large and very small amounts can be
shown in exponential notation (x×10
Simple calculations in the basic arithmetic operations are performed as follows:
1.
Enter the first operand as described.
2.
Click on "+" in order to add, on "-" in order to subtract, on "×" in order to
multiply and on "÷" in order to divide. The specified operators can also be
entered using the numeric keypad and the shortcuts <+>, <->, <*> and </
>.
3.
Enter the next operand.
Electric Drives
| Bosch Rexroth AG
and Controls
Extended Functionality
is shown as xEy, e.g. 4.56E-07).
y
199/233
Advertisement
Table of Contents
