Table of Contents
Advertisement
Application Description | Rexroth IndraMotion MTX 09VRS
Electric Drives
| Bosch Rexroth AG
73/233
and Controls
Operating Modes
Fig.6-12:
NC block display
6.2.6
Acceptance of NC Blocks from the MDI Editor into an NC Program
In order to transfer NC blocks from the MDI editor to an NC program or to
transfer portions of an NC program to the MDI editor, an NC program has to be
opened using the NC editor in the "Program" mode, as has to be an NC screen
in the "Machine" mode using the MDI editor. The NC blocks are exchanged by
highlighting the desired blocks, transferring them to the clipboard (<Ctrl>
+<C>) and pasting them in the desired location in the MDI editor with <Ctrl>
+<V>.
Advertisement
Table of Contents
