Table of Contents
Advertisement
64/233
Bosch Rexroth AG | Electric Drives
Operating Modes
Navigate
Cancel
Functions on the Navigate Level
Beginning of File
End of File
Next Word
Previous Word
Return
Restart with NC Program Restart
Overview
Application
and Controls
Find
A dialog for the entry of a character string to be searched in the whole of the
program opens. You can select uppercase or lowercase, as well as the direction
of the search. Replacement is not possible.
A subsequent level is opened where more functions are grouped.
The function "Block search" or, respectively, "NC program restart" is cancelled.
The Navigate level offers the following functions:
●
BoF
●
EoF
●
Next word
●
Previous word
●
Return
The long cursor jumps to the beginning of the file.
The long cursor jumps to the end of the file.
The cursor jumps to the next word. If the line is exited, the long cursor also
jumps to the new line.
The cursor jumps to the previous word. If the line is exited, the long cursor also
jumps to the new line.
Return to main level
Restarting with NC program restart after program termination provides the op‐
tion of continuing to process the NC program with as little effort as possible, as
far as it has reached respectively exceeded a defined and programmed NC
block (restarting block). The definition of a restarting block is done by program‐
ming the NC function "ReentContBlk()", ( short form "RCB()" ) in the NC
program.
If an NC program is terminated during processing due to different reasons,
processing shall begin at a predefined position immediately. Reasons for ter‐
mination can be tool rupture, power failure, NC control error or others. For these
cases the NC programmer can determine where (NC block) restarting in the
NC program makes sense. This block is marked with "RCB(1)" in the NC pro‐
gram. If the NC program is terminated after this block, restarting with block
search is possible.
Restarting with block search after program termination is only pos‐
sible in operating mode "Sequential block".
The function "Restarting with NC program restart" can be projected to a free F-
or M-key. The function to be projected is "Re-entry".
The default M-key function is the key "R-entry" in the level "Program functions".
Upon program termination, the function "Restart" can be initiated after making
the machine ready for starting. If no re-entry position has been programmed or
if it has been deleted by "RCB(0)", a corresponding message is issued. If an‐
other NC program has been selected in the meantime, this function cannot be
started either.
If a re-entry position has been programmed, but the NC program has been
edited, the function "Re-entry" may be retrieved. Only when starting the NC
Rexroth IndraMotion MTX 09VRS | Application Description
Advertisement
Table of Contents
