Chapter 10 Installation Checklist - Eaton 93PR Installation And Operation Manual

Chapter 10
Installation Checklist
All packing materials and restraints have been removed from each cabinet.

The UPS cabinet is placed in its installed location.

All conduits and cables are properly routed to the UPS and any ancillary cabinets.

All power cables are properly sized and terminated.

Neutral conductors are installed.

A ground conductor is properly installed.

Battery wire has correctly polarity and installation.

Building alarms are wired appropriately. (Optional)

External battery breaker is off and can't be turned on as it is locked by UVT.

Warning label is paste on external battery breaker.

LAN drops are installed. (Optional)

LAN connections have been completed. (Optional)

The REPO device is mounted in its installed location and its wiring is terminated inside the UPS cabinet. (Optional)

A jumper wire is connected between pins 3 and 4 on the REPO terminal block if using a normally-closed REPO switch.

(Optional)
All terminal cover plates are installed.

Accessories are mounted in installed locations and wiring is terminated inside the UPS cabinet. (Optional)

Air conditioning equipment is installed and operating correctly.

The area around the installed UPS system is clean and dust-free. (Eaton recommends that the UPS be installed on a

level floor suitable for computer or electronic equipment.)
Adequate workspace exists around the UPS and other cabinets.

Adequate lighting is provided around all UPS equipment.

A 230 Vac service outlet is located within 7.5 metres (25 feet) of the UPS equipment.

Startup and operational checks are performed by an authorised Eaton Customer Service Engineer, for parallel systems

or installations with accessory cabinets.
Copyright © 2021 Eaton Corporation plc. All rights reserved.
INSTALLATION CHECKLIST
Eaton 93PR 60-1200 kW UPS
Installation and Operation Manual
127