Chapter 11 Appendix A: User Settings; Table 11-1: User Settings; Table 11-2: Config Settings - Eaton 93PR Installation And Operation Manual

Chapter 11
The UPS has the following settings that are user modifiable. In the Home screen, select Settings. User settings:

Table 11-1: User Settings

To modify the Config settings, you need to sign in.
Setting
Info
About
Clear Status
Clear Alarms

Table 11-2: Config Settings

Setting
Language
Unit Name
Clock
Signal Inputs
Relay Outputs
Battery Test
Bypass Limits
Screen Saver Timeout
Meters
Lamp Test
HMI backlight
Control P/W level 1
Config P/W level 2
Copyright © 2021 Eaton Corporation plc. All rights reserved.
APPENDIX A: USER SETTINGS
Description
Information on the UPS model, including part number and
serial number.
Version information.
Reset system Status.
Reset Sticky Alarms.
Description
Change the user interface language.
Change the unit name.
Change the date and time, change the clock for-mat or
enable/disable NTP clock setup.
Select signal input name and function.
Configure the relay outputs.
Change the power level and duration for battery test.
Change bypass voltage, bypass frequency or by-pass slew
rate limits.
Change the screen saver timeout.
Change the meters format.
Enable the lamp test.
Adjust the backlight brightness.
Change the level 1 password, or remove the password on
level 1. The default value is 1111.
Change the level 2 password. The default value is 0101.
Eaton 93PR 60-1200 kW UPS
Installation and Operation Manual
129