Eaton 93PR Installation And Operation Manual page 13

CAUTION
• Installation or servicing should be performed by qualified service personnel knowledgeable of
batteries and required precautions. Keep unauthorized personnel away from batteries. Consider all
warnings, cautions, and notes before installing or replacing batteries. DO NOT DISCONNECT the
batteries while the UPS is in Battery Mode.
• Replace batteries with the same number and type of batteries as originally installed in the UPS.
• Disconnect the charging source prior to connecting or disconnecting terminals.
• Determine if the battery is inadvertently grounded. If it is, remove the source of the ground.
Contacting any part of a grounded battery can cause a risk of electric shock. An electric shock is
less likely if you disconnect the grounding connection before you work on the batteries.
• Proper disposal of batteries is required. Refer to local codes for disposal requirements.
• Do not dispose of batteries in a fire. Batteries may explode when exposed to flame.
• Keep the UPS door closed and front panels installed to ensure proper cooling airflow and to protect
personnel from dangerous voltages inside the unit.
• Do not install or operate the UPS system close to gas or electric heat sources.
• The operating environment should be maintained within the parameters stated in this manual.
• Observe all DANGER, CAUTION, and WARNING notices affixed to the inside and outside of the
equipment.
CAUTION
To prevent damage to the wiring channel and wiring in the UPS cabinet base when lifting or moving the
cabinet:
• Lift and move the cabinet using only the front or rear forklift slots.
• Verify that the forklift forks are in a horizontal position before inserting them into the forklift slots.
DO NOT angle fork tips upward.
• Insert the forks all the way through the base. DO NOT insert forks partially into the base to move the
cabinet.
• Forks may be partially inserted into the front or rear forklift slots for minor positioning if the forks
are kept in a horizontal position with no upward angling.
• DO NOT use the forklift slots on the end of the cabinet to move the cabinet.
• End forklift slots may be used for minor positioning if the forks are kept in a horizontal position with
no upward angling.
If these instructions are not followed, damage to the wiring channel and wiring will occur.
Copyright © 2021 Eaton Corporation plc. All rights reserved.
Eaton 93PR 60-1200 kW UPS
Installation and Operation Manual
1