Lexmark XM5100 Series User Manual page 165

Understanding the printer menus
Use
ENA Gateway
yyy.yyy.yyy.yyy
Parallel [x] menu
Note: This menu appears only when an optional parallel card is installed.
Use
PCL SmartSwitch
On
Off
PS SmartSwitch
On
Off
NPA Mode
On
Off
Auto
To
Set the gateway information for an external print server.
Note: This menu is available only when the printer is attached to an external
print server through the USB port.
To
Set the printer to automatically switch to PCL emulation when a print job
received through a serial port requires it, regardless of the default printer
language.
Notes:
•
On is the factory default setting.
•
When set to Off, the printer does not examine incoming data. The printer
uses PostScript emulation if PS SmartSwitch is set to On. It uses the
default printer language specified in the Setup menu if PS SmartSwitch is
set to Off.
Set the printer to automatically switch to PS emulation when a print job received
through a serial port requires it, regardless of the default printer language.
Notes:
•
On is the factory default setting.
•
When set to Off, the printer does not examine incoming data. The printer
uses PCL emulation if PCL SmartSwitch is set to On. It uses the default
printer language specified in the Setup menu if PCL SmartSwitch is set to
Off.
Set the printer to perform the special processing required for bidirectional
communication following the conventions defined by the NPA protocol.
Notes:
•
Auto is the factory default setting.
•
Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is then updated.
165