Reports Menu - Lexmark XM5100 Series User Manual

Understanding the printer menus
Use
Portrait Width
3–8.5 inches
76–216 mm
Portrait Height
3–14.17 inches
76–360 mm
Feed Direction
Short Edge
Long Edge

Reports Menu

Reports menu
Use
Menu Settings Page
Device Statistics
Network Setup Page
To
Set the portrait width.
Notes:
•
If the width exceeds the maximum, then the printer uses the
maximum width allowed.
•
8.5 inches is the US factory default setting. You can increase
the width in 0.01‑inch increments.
•
216 mm is the international factory default setting. You can
increase the width in 1‑mm increments.
Set the portrait height.
Notes:
•
If the height exceeds the maximum, then the printer uses the
maximum height allowed.
•
14 inches is the US factory default setting. You can increase the
height in 0.01‑inch increments.
•
356 mm is the international factory default setting. You can
increase the height in 1‑mm increments.
Specify the feed direction if the paper can be loaded in either
direction.
Notes:
•
Short Edge is the factory default setting.
•
Long Edge appears only when the longest edge is shorter than
the maximum width supported in the tray.
To
Print a report on the current printer menu settings. The report also contains
information about the status of the supplies and a list of hardware options
that are successfully installed.
Print a report containing printer statistics, such as supply information and
number of printed pages.
Print a report containing information about the network settings of the
printer.
Note: This menu item appears only in network printers or printers
connected to print servers.
156