Adjusting The Throttle Valve - APRILIA RSV mille 956X Service And Repair Manual

RSV mille

4.8.9 ADJUSTING THE THROTTLE VALVE

POTENTIOMETER
a
CAUTION
The two sunk hexagon cheese-head screws fasten-
ing the throttle valve potentiometer (1) are painted
during production and cannot be loosened.
The throttle valve potentiometer can only be adjusted
in the event of replacement.
Place the throttle valve potentiometer (1) in a horizontal
position on the throttle valve shaft and rotate it down-
wards.
NOTE
Apply LOCTITE
screws (2).
Screw on the two M4x12 T.C.E.I. sunk hexagon
cheese-head screws (2) and tighten the throttle valve
potentiometer quite firmly, but so that the screws can
still be turned further.
Turn the ignition switch to position "
To connect the TEST connectors (3).
Turn the throttle valve potentiometer until the display

longer reads " " .
a
CAUTION
Any adjustment of the position sensor must be per-
formed with the valves closed, meaning the throttle
valve control lever (4) must touch the adjusting screw
(5).
Tighten the two M4x12 T.C.E.I. sunk hexagon cheese-
head screws (2).
Driving torque of screws (2): 1.6 Nm (0.16 kgm).
Turn the ignition switch to position "
For further details see 6.4.11 (CHECKING THE IN-
TAKE PRESSURE SENSOR).
®
243 on the thread of the
n
".
m
".
FUEL SUPPLY SYSTEM
4 - 23