APRILIA RSV mille 956X Service And Repair Manual page 232

RSV mille
 2%-/6).' 4(% #//,!.4 4(%2-!,
37)4#(
Carefully read 0.2.1 (PRECAUTIONS AND GENERAL
INFORMATIONS) and 1.2.5 (COOLANT).
Turn the ignition switch to position "
Remove the left side fairing, see 7.1.26 (REMOVING
THE SIDE FAIRINGS).
Disconnect the electric connectors (1-2) from the ther-
mal switch (3).
a
CAUTION
When reassembling, make sure the electric connec-
tors (1-2) are plugged in properly.
Prepare a new thermal switch and apply LOCTITE
572 on its thread.
Unscrew and remove the thermal switch (3) and re-
trieve the gasket.
Insert the gasket on the new thermal switch.
Screw the thermal switch (3) on by hand before tighten-
ing it.
Driving torque of thermal switch (3): 30 Nm (3.0 kgm).
If any coolant spilled during removal, once the opera-
tion is complete, top up the coolant, see 2.15 (CHECK-
ING AND TOPPING UP COOLANT).
NOTE
See 6.9.3 (CHECKING THE THERMAL
SWITCH OPERATION) for further details on the thermal
switch.
a
CAUTION
Plug the hole on the three-way manifold so as to pre-
vent any foreign bodies from falling in.
 2%-/6).' 4(% #//,!.4 4(%2-)34/23
Carefully read 0.2.1 (PRECAUTIONS AND GENERAL
INFORMATIONS) and 1.2.5 (COOLANT).
NOTE
The following procedure refers to a single ther-
mistor, though it is applicable to both.
Lift the fuel tank, see 2.8 (LIFTING THE FUEL TANK).
Disconnect the electric connector (4).
a
CAUTION
When reassembling, make sure the electric connec-
tor (4) is plugged in properly.
Prepare a new thermistor and apply LOCTITE
its thread.
Unscrew and remove the thermistor (5).
Screw the thermistor (5) on by hand before tightening it.
Driving torque of thermistor (5): 30 Nm (3.0 kgm).
If any coolant spilled during removal, once the opera-
tion is complete, top up the coolant, see 2.15 (CHECK-
ING AND TOPPING UP COOLANT).
NOTE
Where necessary, remove the other thermistor.
See 6.4.8 (CHECKING THE COOLANT THERMISTOR
OPERATION) for further details on the thermistors.
m
" .
®
®
574 on
COOLING SYSTEM
2
3
1
5
4
5 - 7