Adjusting The Throttle Body - APRILIA RSV mille 956X Service And Repair Manual

FUEL SUPPLY SYSTEM

4.8.8 ADJUSTING THE THROTTLE BODY

Partially remove the fuel tank, see 7.1.4 (PARTIAL RE-
MOVAL OF THE FUEL TANK).
Remove the air filter casing, see 7.1.7 (REMOVING
THE AIR CLEANER CASE).
SETTING IDLING
a
CAUTION
The idling adjusting screw (1) is painted and cannot
be adjusted.
Only when the whole throttle cable support bracket is
replaced can the adjusting screw (1) be turned again.
Loosen the M5x0.5 nut (2).
Unscrew the adjusting screw (1) until the throttle valves
(3) are pressed up against the throttle body (4).
Screw the adjusting screw (1) until it touches the stop
onto the throttle valve control lever (5), and turn it an-
other 1/2 - 3/4 turn before tightening the M5x0.5 nut (2).
Idling setting: 1/2 – 3/4 turn.
SETTING THE COLD-START DEVICE
a
CAUTION
Whenever the whole throttle cable support bracket is
replaced, the cold-start control adjusting screw (6)
must be adjusted again once the idling adjusting
screw (1) has been set.
NOTE
Have an appropriate thickness gauge.
Loosen the M5x0.5 nut (7).
Pull back the cold-start lever (8) until it touches the
screw (6).
Adjust the screw (6) so that the clearance between the
idling adjusting screw (1) and the throttle valve control
lever (5) is in the range 1.6 to 1.8 mm.
Adjustment: 1.6 – 1.8 mm.
Secure the screw (6) by tightening the M5x0.5 nut (7).
4 - 22
RSV mille