APRILIA RSV mille 956X Service And Repair Manual page 204

RSV mille
 $2!).).' 4(% &5%, 4!.+
See 2.9 (DRAINING THE FUEL TANK) for the fuel tank
draining procedure.
 2%-/6).' 4(% 7(/,% &5%, 3500,9
05-0 5.)4
Carefully read 0.2.1 (PRECAUTIONS AND GENERAL
INFORMATIONS), 1.2.1 (FUEL) and 4.1.1 (MAINTE-
NANCE).
Remove the fuel tank completely, see 7.1.5 (COM-
PLETE REMOVAL OF THE FUEL TANK).
a
CAUTION
Handle the fuel tank with care and avoid scraping or
damaging them.
NOTE
Set the tank on a clean surface with the pump
unit facing up.
Unscrew and remove the screws (1).
NOTE
When reassembling, screw all the screws on
manually and tighten them in a crisscross pattern in the
following order: A-B-C-D-E-F-G-H.
Driving torque of screws (1): 7 Nm (0.7 kgm).
NOTE
Obtain appropriate pliers to attach the clamps,
or screwdriver-type pipe clamps to replace the original
ones (special type without screw).
Lift the pump unit (2) just enough to be able to get at the
pipe clamps (3 - 4).
Release the head off the pipe clamps (3 - 4).
a
CAUTION
When removing the pump unit (2), take care not to
damage the pipes and the fuel level sensor (5).
Remove the whole pump unit (2).
 2%-/6).' 4(% &5%, ,%6%, 3%.3/2
Remove the whole fuel supply pump unit, see 4.3 (RE-
MOVING THE WHOLE FUEL SUPPLY PUMP UNIT).
Release and remove the clamp (6).
Before removing the screws (7 - 8), make sure the rele-
vant electric terminals fastened on them are positioned
correctly.
Unscrew and remove the screw (7).
Unscrew and remove the screws (8).
Remove the sensor (5).
NOTE
When reassembling, position the terminals of
the electric cables correctly, in the relevant fastening po-
sitions, using the screws (7 - 8).
FUEL SUPPLY SYSTEM
4 - 5