(%!$,)'(4 - APRILIA RSV mille 956X Service And Repair Manual

RSV mille

 !$*534).' 4(% 6%24)#!, (%!$,)'(4

"%!-
NOTE
To check the direction of the headlight beam,
specific procedures must be adopted, in accordance with
the regulations in force in the country where the vehicle is
used.
To rapidly check the correct direction of the beam, place
the vehicle on flat ground, 10 m away from a wall.
Turn on the low beam, sit on the vehicle and make sure
that the beam projected on the wall is slightly under the
horizontal line of the headlight (about 9/10th of the total
height).
To adjust the headlight beam:
Working on the rear left side of the front part of the fair-
ing, adjust the apposite screw (1) by means of a short
cross-tip screwdriver.
By SCREWING IT (clockwise), you set the beam up-
wards.
By UNSCREWING IT (anticlockwise), you set the beam
downwards.
 !$*534).' 4(% (/2):/.4!,
(%!$,)'(4 "%!-
NOTE
To check the direction of the headlight beam,
specific procedures must be adopted, in accordance with
the regulations in force in the country where the vehicle is
used.
NOTE
Before proceeding with the horizontal adjustment
of the high beam, the vertical adjustment of the headlight
beam must be performed, see 6.13 (ADJUSTING THE
VERTICAL HEADLIGHT BEAM).
Working from the right-hand side of the vehicle, adjust
the relevant screw (2) by means of a short Phillips
screwdriver.
By SCREWING IT (clockwise) moves the beam to the
left.
By UNSCREWING IT (anticlockwise) moves the beam
to the right.
I
-
ELECTRICAL SYSTEM
6 - 35