APRILIA RSV mille 956X Service And Repair Manual page 148

RSV mille
ASSEMBLY
NOTE
Have the appropriate special tools
– (14) handle for pads;
– (15) cod. 0277670 (coolant pump shaft housing oil
seal assembly pad);
– (16) cod. 0877257 (coolant pump shaft housing sliding
ring assembly pad).
NOTE
The closed side of the oil seal must be fitted so
that it faces the impeller (3).
Insert the oil seal (7) all the way into the slot using the
assembly punch.
NOTE
The closed side of the oil seal must be fitted so
that it faces the impeller (3).
Insert the sliding sealing ring (8) all the way in using the
assembly pad.
a
CAUTION
Take care not to damage the impeller (3).
Screw the impeller (3) firmly onto the coolant pump
shaft (6).
Coat the coolant pump shaft (6) with MOLYKOTE® G-
N and insert it from the outside all the way onto the oil
seal assembly.
Install the washer (5) on the coolant pump shaft.
Install the pin (4) in the coolant pump shaft slot and en-
gage the coolant pump gear (2).
NOTE
You must feel the pin is perfectly inserted in the
slot in the coolant pump gear.
Tighten the impeller (3) by hand, holding the coolant
pump gear (2) still.
®
M = MOLYKOTE G-N.
&
to hand:
ENGINE
3 - 65