Changing The Front And Rear Direction Indicator Bulbs; Changing The Rear Light Bulb - APRILIA RSV mille 956X Service And Repair Manual

RSV mille
6.12.2 CHANGING THE FRONT AND REAR
DIRECTION INDICATOR BULBS
Position the vehicle on the stand.
NOTE
Before changing a bulb, check the fuses, see
6.15 (CHANGING THE FUSES).
Unscrew and remove the screw (1).
a
CAUTION
While removing the protection screen, proceed care-
fully in order not to break the lug.
Remove the protection screen (2).
a
CAUTION
Upon reassembly, correctly position the protection
screen in its seat.
Tighten the screw (1) moderately and carefully, to
avoid damaging the protection screen.
Press the bulb (3) slightly and rotate it anticlockwise.
Extract the bulb (3) from its seat.
NOTE
Insert the bulb in the bulb socket, making the two
bulb pins coincide with the relevant guides on the socket.
Correctly install a new bulb of the same type.
NOTE
If the bulb socket (4) goes out of its seat, insert it
correctly, making the bulb socket opening coincide with the
screw seat.

6.12.3 CHANGING THE REAR LIGHT BULB

NOTE
The rear light houses two parking light/stoplight
bulbs (5).
The following operations refer to a single bulb, but are
valid for both.
Position the vehicle on the stand.
NOTE
Before changing a bulb, check the fuses, see
6.15 (CHANGING THE FUSES) and the efficiency of the
stoplight switches, see 6.16 (CHECKING THE SWITCH-
ES).
Unscrew and remove the two screws (6).
Remove the protection screen (7).
a
CAUTION
Upon reassembly, correctly position the protection
screen in its seat.
Tighten the screw (6) carefully, without exerting too
much pressure, in order to avoid damaging the pro-
tection screen.
Press the bulb (8) slightly and rotate it anticlockwise.
Extract the bulb (8) from its seat.
NOTE
Insert the bulb in the bulb socket, making the two
bulb pins coincide with the relevant guides on the socket.
Correctly install a new bulb of the same type.
ELECTRICAL SYSTEM
6 - 33