APRILIA RSV mille 956X Service And Repair Manual page 138

RSV mille
Check the following components for wear:
– roller bearings (1);
– sides of the teeth (2) of all gears.
NOTE
Small grey marks and tiny hollows are tolerated
up to a maximum corresponding to approx. 0.5% of the
sides surface area.
– engagement teeth (3) and mating slots of gearshift
gears;
– profile for spline shafts (4) of the secondary shaft and
primary shaft;
– check all the gear selection gears (5), both on the sec-
ondary shaft and primary shaft, slide smoothly;
– housings of the idle gear bearings (6);
– triangular tooth profile (7) of the chain pinion;
– the grooves for seeger rings (8) on the secondary shaft
and on the primary shaft must have sharp edges.
ENGINE
3 - 55