Assembling The Primary Transmission And Clutch - APRILIA RSV mille 956X Service And Repair Manual

ENGINE
3.7.9 ASSEMBLING THE PRIMARY TRANSMISSION
AND CLUTCH
Carefully read 0.2.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
Coat the end of the driving shaft with LOCTITE
Seize.
NOTE
The collar of the drive gear must face down.
Insert the drive gear (1) on the driving shaft.
Fit the spring washer, then fasten and tighten the
M33x1.5 T.E. nut (2), coating it with LOCTITE
Driving torque of nut (2): 230 Nm (23.0 kgm).
Insert the washer (3) on the primary shaft.
Coat the housing and toothing of the primary shaft (4)
®
with LOCTITE Anti Seize.
a
CAUTION
Once disassembled, always replace the oil pump
gear.
Place a new oil pump gear (5) on the preassembled
clutch drum (6) and engage it.
Insert the preassembled clutch drum (6) on the primary
shaft (4).
NOTE
Turn the oil pump gear (7) so that the toothing
mates with the toothing of the pinion (5).
Fit the serrated thrust ring (8), the clutch hub (9) and
the spring washer (10) on the primary shaft.
3 - 94
®
Anti
®
243.
RSV mille