APRILIA RSV mille 956X Service And Repair Manual page 139

ENGINE
Check the housings of the secondary shaft and primary
shaft for wear:
– wear limit (9) min. Ø 19.972 mm;
– wear limit (10) min. Ø 29.915 mm;
– wear limit (11) min. Ø 29.965 mm;
– wear limit (12) min. Ø 24.972 mm;
– wear limit (13) min. Ø 29.03 mm;
– wear limit (14) min. Ø 24.978 mm;
– permissible eccentricity (15) max. Ø 0.02 mm.
NOTE
Should the sides of the teeth be worn, the relevant
pair of gears must be replaced.
Should the engagement teeth or mating slots prove worn, the
relevant gears must be replaced, mating with each other.
Check the internal diameter of the idle gears of 3
th
6 gear.
Wear limit (16) max. Ø 29.022 mm.
Check for any signs of rolling or grooves on the bushes of
nd
the idle gears of 2 (17) and 5
ternal diameter of the gears.
Check for any signs of rolling or grooves on the bushes of
the idle gears (15 - 16), and measure the internal diameter
of the bearings.
Wear limit max. Ø 29.125 mm.
Make sure the lubrication hole (18) of the secondary shaft is
clear.
3 - 56
rd th
, 4 and
th
gear, and measure the in-
RSV mille