APRILIA RSV mille 956X Service And Repair Manual page 58

RSV mille
 #(!.').' 4(% #,54#( &,5)$
Carefully read 0.2.1 (PRECAUTIONS AND GENERAL
INFORMATIONS) and 1.2.6 (CLUTCH FLUID).
Change the clutch fluid every two year.
a
CAUTION
Handle clutch fluid with care; it may chemically alter
painted surfaces and the parts in plastic, rubber, etc.
DO NOT DISPOSE OF CLUTCH FLUID IN THE ENVI-
RONMENT.
Remove the plastic protection cap.
Insert a transparent plastic tube on the bleeder (1) and
put the other end of the tube in a container.
Loosen the bleeder (1) approx. one turn.
NOTE
Make sure that there is always fluid in the tank
during the operation; otherwise, once finished, the clutch
system will need bleeding, see 2.21 (BLEEDING THE
CLUTCH SYSTEMS).
Keep an eye on the tank (2) as the fluid flows out and
tighten the bleeder (1) before it empties entirely.
Top up the tank (2), see 2.19 (CHECKING AND TOP-
PING UP THE CLUTCH FLUID).
Loosen the bleeder (1) again approx. half a turn.
Watch as the liquid flows out through the tube and as
soon as the colour of the fluid starts to change (from
dark to light), tighten the bleeder (1) again and remove
the tube.
Driving torque of bleeder (1): 15 Nm (1.5 kgm).
Refit the rubber protection cap.
Top up the fluid tank (2) to the right level, see 2.19
(CHECKING AND TOPPING UP THE CLUTCH FLU-
ID).
 !$*534).' 4(% 2%!2 "2!+%
#/.42/, ,%6%2 !.$ 4(% '%!2 ,%6%2
The control levers are positioned ergonomically during
the assembly of the vehicle.
If necessary, it is possible to adjust the position of the le-
vers.
Position the vehicle on the side stand on firm and level
ground.
Partially unscrew the screw (3).
Rotate the eccentric (4) in order to find the optimal po-
sition of the pedal (5).
Tighten the screw (3) and make sure that the eccentric
is stable in its position.
SERVICE AND SETTING UP
2
2 - 31