Assembling The Oil Pump - APRILIA RSV mille 956X Service And Repair Manual

ENGINE

3.7.6 ASSEMBLING THE OIL PUMP

Carefully read 0.2.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
a
CAUTION
®
Make sure the LOCTITE
the suction pump hole.
Apply a thin film of LOCTITE
face (1) of the oil pump casing.
Insert the duly oiled external rotor (2) in the slot in the
casing.
NOTE
The reference point must face down (towards
the engine casing).
Insert the pin (3) in the last hole at the bottom of the oil
pump shaft (4).
Insert the internal rotor (5) in the oil pump shaft (4), with
the housing slot facing up.
Insert the oil pump shaft (4) in the casing, complete with
internal rotor.
a
CAUTION
®
Make sure the LOCTITE
the pressure pump hole.
Apply a thin film of LOCTITE
ket surface of the oil pump casing (6) and install it on
the oil pump shaft (4).
Fasten the oil pump casing (6), complete with pin (7),
inside the casing.
Insert the pin (8) in the central hole of the oil pump
shaft.
Insert the duly oiled internal rotor (9) of the pressure
pump on the oil pump shaft, with the driving groove fac-
ing down.
Insert the duly oiled external rotor (10) in the oil pump
casing.
Fasten the oil pump cover (11) with the four T.C.E.I.
screws (12).
Driving torque of screws (12): 11 Nm (1.1 kgm).
Insert the pin (13) in the hole of the oil pump shaft.
NOTE
The oil pump cover features a groove (14) ena-
bling the pin to be fitted.
Line the pin up with the centre of the oil pump shaft.
®
D = LOCTITE 574.
3 - 90
product does not get inside
®
574 on the gasket sur-
product does not get inside
®
574 on the external gas-
RSV mille