ENGINE
%.').% #(%#+3 35"3%15%.4 4/
2%!33%-",9
Carefully read 0.2.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
3.8.1 BLEEDING THE ENGINE OIL CIRCUIT
Refill the engine with motor oil, see 2.14 (CHANGING
THE ENGINE OIL AND THE OIL FILTER).
Slip the two electric connectors off the two injectors (1-
2).
Start the engine for a moment until the engine oil pres-
sure LED goes off.
Insert the two electric connectors on the two injectors
(1-2).
Top up with motor oil until the tank level reaches the
prescribed limit, see 2.13 (CHECKING THE ENGINE
OIL LEVEL AND TOPPING UP).
Start the engine and let it idle for approx. 10 minutes.
Check the oil level again and, where necessary, top up.
3.8.2 CHECKING THE ENGINE OIL PRESSURE
NOTE
Have the appropriate special tool
cod. 8140181 (fuel-oil pressure gauge).
Connect the oil pressure gauge (4) in place of the en-
gine oil pressure sensor (3).
Engine oil pressure: min. 50 kPa (0.5 bar).
NOTE
Check the oil pressure at a temperature of 80 °C
(176 °F) and at a speed of at least 1200 rpm.
a
CAUTION
If the oil pressure is below the minimum limit, check
the oil pump and relevant drive assembly.
During reassembly, coat the thread of the engine oil
pressure sensor (3) with LOCTITE
Driving torque of sensor (3): 15 Nm (1.5 kgm).
3.8.3 SYNCHRONIZING CYLINDERS
See 4.8.10 (CYLINDER SYNCHRONIZATION).
3
- 116
&
(3) to hand
®
243.
RSV mille