APRILIA RSV mille 956X Service And Repair Manual page 175

ENGINE
Guide the chain tightener shoe (22) through the chain
compartment and fasten it in the housing by means of
the spacer bush (23).
Oil the two roller bearings (24) and push them onto the
bearing pins of the bearing flange (25).
NOTE
Insert the bearing flange all the way in, tapping
gently with a plastic hammer.
The two calibrated bushes (29) must previously have
been fastened in the casing.
Insert the bearing flange (25) and fasten it using the
three M8 T.C.E.I. screws (26-27) and the spring wash-
ers (28), i.e.:
– two M8x45 screws (26);
– one M8x20 screw (27).
Driving torque of screws (26-27): 25 Nm (2.5 kgm).
O = Motor oil.
Check the rotation of the intermediate drive gear.
Insert the key (30) in the driving shaft.
The reference mark (31) on the intermediate drive gear
must coincide with the reference mark (32) on the cas-
ing.
Apply a coat of LOCTITE
driving shaft (33).
Push the drive gear (34) onto the driving shaft.
3 - 92
®
Anti Seize on the end of the
RSV mille