Table of Contents
Advertisement
2. Press the → key to access the PVC parameters screen.
3. Set the Voice PVC Supported Service parameter for the EXTender link to Add/Drop1 or Add/Drop2.
Note: Add/Drop1 will allocate DS0 channels to WAN1 and Add/Drop2 will allocate DS0 channels to
WAN2.
4. Set the DLCI (Data Link Connection Identifier) for this PVC (16 - 1007). This number is given to you by
your service provider. The DLCI field defaults to blank and is cleared automatically if you set the PVC
type to "Not In Use."
5. Set the Maximum Bandwidth to the specified amount of guaranteed bandwidth (measured in bits per
second) on a Frame Relay service. Use MCK's Bandwidth calculator.
6. Repeat steps 3 -5 for each additional PVC (ie. Add/Drop PVC(s)).
7. Use the ← and ↓ keys to return to the Save option.
8. Press Enter to save changes to the active config (.rem) file.
TM
EXTender
7000 Installation Guide
Figure 4-8: PVC_1
Page 56
Advertisement
Table of Contents
