Setting The Interface Type - MCK EXTender 7000 Installation Manual

Setting the Interface Type

1. Access the WAN 1 or WAN 2 Menu using the following path:
MI Path
Configuration->WAN 1 or 2
2. The WAN menu appears. Press the → key to access the parameters.
3. Press the ↓ key to the Interface Type parameter, which has the following values:
Value
DCE
DTE
Notes:
DTE is typically used to connect to a third party CSU/DSU for RVP_Direct (Serial RVP) installations.
DCE is typically used in Add/Drop configurations (connecting to an EXTender 6000 or a Router). In DCE
installations, you must use the 25 pin Female-to-Female crossover cable (DB-25, RS-530) that we pro-
vide.
4. For most connections, you will want to set the this parameter to DTE.
5. Press the ← key to accept changes and go back to the Configuration Menu.
6. Press the ↓ key to the Save parameter.
7. Press Enter to save changes to the active config (.rem) file.
TM
EXTender 7000 Installation Guide
The WAN port on the EXTender 7000 connects to a DTE device.
The WAN port on the EXTender 7000 PBXgateway II connects to a DCE
device.
Figure 3-11: Interface Type
Description
Page 33