Chapter 5: Isoplane Setup; Unpack And Inspect Equipment; Initial Setup Procedure - Teledyne Everywhereyoulook IsoPlane 320A Manual

Chapter 5: IsoPlane Setup

This chapter provides information about the initial setup and configuration of an IsoPlane
spectrograph.

5.1 Unpack and Inspect Equipment

Carefully unpack and examine the IsoPlane and all purchased accessories.

5.2 Initial Setup Procedure

Perform the following procedure to setup the IsoPlane for the first time:
1.
2.
Figure 5-1: External Connector Panel
3.
4.
REFERENCES:
For detailed information about the operation of an IsoPlane
spectrograph, refer to
NOTES:
Report any damage immediately to the carrier and to
1.
Princeton Instruments.
Save all packing material.
2.
Position the IsoPlane where it will be used.
Connect the power supply shipped with the IsoPlane to the
on the side of the IsoPlane. See
The power supply provides +5 V
drives.
With the power supply switch in the off position, connect the line cord provided with
the IsoPlane to the power supply and the AC line. The power supply will operate with
line voltages between 100 and 240 V
The IsoPlane is designed to be controlled primarily through Princeton Instruments'
®
LightField or WinSpec data acquisition and control software when operated with a
Princeton Instruments detector. Connect the USB port of the IsoPlane to the USB port
on the control computer using the USB cable provided.
The RS-2332 interface may also be used if a USB port is not available. If using the
RS-232 interface, configure the appropriate port on the host computer as described in
Section D.1, Communication Configuration
Chapter 6, Operation, on page 43.
Figure 5-1.
for the control logic and +24 V
DC
, 50/60 Hz.
AC
Settings, on page 71.
connector located
POWER
POWER
for the motor
DC
31