Table of Contents
Advertisement
24
Position the grating turret on the grating spindle so the hole in the turret assembly aligns
11.
with the post in the turret assembly as shown in
Figure 3-13: Turret Installed with Hole and Post Aligned
Verify that the turret is properly seated.
12.
Tighten the center torque screw until it clicks. This sets the torque on the spindle
13.
correctly.
Place the Turret Cover on the spectrograph. Replace and tighten all cover screws.
14.
If the IsoPlane's power supply is on, restart the IsoPlane to initiate the automatic
15.
identification of the new grating turret.
If the power supply is off, the automatic identification will be initiated once the power
supply is turned on.
NOTE:
This screw cannot be over-tightened. It is designed to slip once
the correct torque has been attained.
Figure
3-13.
A
LIGNED
H
P
OLE AND
OST
Advertisement
Table of Contents
