Chapter 3
Before removing the replacement grating turret from its shipping container, use a 3/32"
7.
hex wrench to loosen the three (3) set screws on the bottom of the container
approximately one turn.
Remove the cover from the shipping container, grasp the center torque screw, and turn it
8.
counterclockwise until the turret can be lifted straight up.
Locate the hole near the edge between gratings on the grating turret assembly. See
9.
Figure
Figure 3-11: Location of Hole on Turret Grating Assembly
Locate the vertical post on the grating spindle assembly. See
10.
Figure 3-12: Location of Post on Grating Spindle Assembly
Grating Turrets
3-11.
P
OST
H
OLE
Figure
3-12.
23