Table of Contents
Advertisement
Chapter 4: Internal Shutter
The IsoPlane has an optional internal shutter. If the
shutter is installed, it is located in the Turret
Compartment and is mounted to the spectrograph
wall. Its shutter cable plugs into a keyed 2-pin shutter
connector in the floor of the IsoPlane. The external
connector is below the detector mounting plate and
can be connected via a shutter cable to a detector with
a SHUTTER connector. If a detector does not have a
SHUTTER connector (e.g., PI-MAX detectors,) the
Princeton Instruments SHC-EXT Shutter Control
Box can be used to control the opening and closing of
the internal shutter. If the control box is not available, the internal shutter can be removed.
4.1 Internal Shutter Installation/Removal
An IsoPlane may be ordered with an optional internal shutter at
the entrance slit. This shutter is controlled by either:
This section provides procedures for the installation and removal
of an internal shutter.
REFERENCES:
For information about the installation and removal of the internal
shutter assembly, refer to:
•
Section 4.1.1, Install an Internal
•
Section 4.1.2, Remove an Internal
A detector via a shutter cable from the detector's Shutter
•
connector to the Shutter connector on the IsoPlane, or
A Shutter Control box (Model SHC-EXT) available from
•
Princeton Instruments.
Shutter, on page 26,
Shutter, on page 27.
25
Advertisement
Table of Contents
