Horizontal Alignment Procedure; Systems Equipped With The Sliding Spec Flange Adapter - Teledyne Everywhereyoulook IsoPlane 320A Manual

38
If the image is
2.
the image is centered about the center row of the camera.
If the image is still positioned too high, continue making incremental adjustments to the
Cap and Set Screws until the image is properly centered.
If the image is
3.
the image is centered.
If the image is still positioned too low, continue making incremental adjustments to the
Set and Cap Screws until the image is properly centered.
5.6.2

Horizontal Alignment Procedure

The procedure for horizontally aligning an image depends on the specific camera adapter
being used.
•
•
5.6.2.1

Systems Equipped with the Sliding Spec Flange Adapter

For systems equipped with the Sliding Spec Flange adapter,
adjustments are to be done by adjusting the camera's positioning on the IsoPlane by
performing the following procedure:
Loosen, but do not remove, the four screws securing the Sliding Spec Flange adapter to
1.
the IsoPlane.
Carefully slide the adapter horizontally to shift the camera's position on the IsoPlane.
2.
Acquire an image, and check the horizontal alignment.
3.
If necessary, repeat step 2 and step 3 until the image is properly aligned with the
4.
camera's sensor.
Once the image is properly aligned, tighten the four screws on the Sliding Spec Flange
5.
mount.
, alternately loosen the Cap Screw and tighten the Set Screw until
HIGH
!
CAUTION!
Adjust ONLY the cap and set screw specified in
Adjustments to other screws may result in severe misalignment of
the instrument.
, alternately loosen the Set Screw and tighten the Cap Screw until
LOW
!
CAUTION!
Adjust ONLY the cap and set screw specified in
Adjustments to other screws may result in severe misalignment of
the instrument.
Systems equipped with a Sliding Spec Flange Mount must use the procedure
described in Section 5.6.2.1, Systems Equipped with the Sliding Spec Flange
Adapter.
REFERENCES:
Refer to Section B.1, Sliding Spec Flange
additional information about this adapter.
Systems equipped with any other camera adapter are aligned using the procedure
described in Section 5.6.2.2, Systems Equipped with a NON-Sliding Spec Flange
Adapter, on page 39.
Figure 5-5.
Figure 5-5.
Mount, on page 57 for
horizontal alignment
ALL