Table of Contents
Advertisement
Chapter 1
1.3.1
External Connector Panel
Figure 1-4
External Connector panel.
Figure 1-4: External Connectors
The following interfaces are accessible through this connector panel:
•
•
•
•
•
•
•
•
•
illustrates the indicators, interfaces, and associated connectors found on the
FILTER
Filter driver connection required for an Acton FA-2448 Filter Wheel.
SHT TTL
SHT TTL connection for TTL control of shutter.
DSP
DSP connector used to connect two spectrographs as doubles.
COM
This yellow LED flashes to indicate that the IsoPlane is successfully
communicating with the host computer.
READY
This Green/Yellow LED indicates the operational status of the IsoPlane
spectrograph/system:
Green
—
Indicates that the system has been initialized;
Yellow
—
Indicates that the system is busy.
RS-232
RS-232 connection to the host computer. Refer to
on page 71 for additional information about using this interface.
USB
USB connection to the host computer.
USB HUB
USB Hub 1.1 compatible.
POWER
External power connector. The external power supply provides the following
voltages to the IsoPlane:
+5 V
—
DC
+24 V
.
—
DC
Refer to
Section 1.1.1, External Power
information.
Appendix D, RS-232
Supply, on page 6 for additional
9
POWER
Interface,
Advertisement
Table of Contents
