Table of Contents
Advertisement
22
Figure 3-9: Grating Turret: Center Torque Screw
Grasp the center torque screw and carefully lift the grating turret straight up off the
5.
grating spindle assembly. If the turret cannot be lifted up, the center torque screw may
need to be loosened a bit more. See
Figure 3-10: Removing the Grating Turret from the Grating Compartment
Carefully place the removed grating turret assembly into the original protective
6.
container in which it was shipped. Be sure to align the post and hole. Tighten the center
torque screw and use a 3/32" hex wrench to tighten the three (3) set screws on the
bottom of the container approximately one turn.
!
CAUTION!
Use extreme care so as not to touch the grating surfaces.
Figure
3-10.
C
T
ENTER
ORQUE
S
CREW
Advertisement
Table of Contents
