Chapter 4
Carefully slide the shutter up and off the two mounting screws to remove it. Place the
5.
shutter in a safe location for storage.
Using the 9/64" hex wrench, tighten the two mounting screws so that they are snug and
6.
will not accidentally fall out.
Carefully install the grating turret. Refer to
7.
for complete information.
Place the turret compartment cover on the IsoPlane.
8.
Install and tighten all cover screws.
9.
Internal Shutter
!
CAUTION!
Exercise extreme caution when handling the grating turret so as
not to touch the grating surfaces.
Section 3.1, Turret
Installation, on page 15
29